|You should be left with and empty rear and since our new setup remounts the shocks. We will remove those next.|
Using the instructions and the supplied brackets. We measure from the rear shackle mount made our marks using a metal marker and drilled our holes. This completes the rear mounting setup.
|The front mounts in where the factory leaf springs bolted in. Two additional holes need to be made and then the front can be bolted down. Now we can start assembling the new rear end with brackets secured.|
|Using the supplied hardware and coil over, the setup is quick and easily bolted in. The great part about this setup is that its completely adjustable. You can adjust the ride height, drive line angle, preload, axle center point and ride stiffness.|
|After welding the brackets to the housing. Its now ready to be painted and bolted in. Side note this housing also is available with the brackets already welded on.|
|For axles we're using Heidt's case hardened 31 spline axles with a 5 x 4.5 bolt pattern to fit our ford bolt pattern.|
|We're using a disc brake setup with built it e-brake from The Right Stuff brake company.|
Too Be Continued....